How
to Clean Chips
- Use
a very soft bristled toothbrush.
- Let
experts clean very old or expensive chips.
- A
pencil eraser is good for removing scuffs and crud from old chips.
- These cleaners have been
reported to have good results cleaning chips: mild dishwashing detergent, Armor
All Multi-Purpose Cleaner, Quick'n'Brite, Sterling Magic.
- The
trick seems to be to find something that will dissolve the greasy deposits that
accumulate on well used chips, without removing any ink, or leeching moisture
from the chip. Quick'n'Brite is a thick paste, and does not seem to encourage
any moisture transfer, while doing an excellent job of breaking down the greasy
gunk. I just stick the chip in the bucket edgewise, rotate it a few time to coat
the chip thoroughly, wait about 15-30 seconds, then wipe the chip down with a
washcloth. It's revolting how dirty that washcloth gets after only a few chips.
- I use
Sterling Magic full strength with a toothbrush. I use no water and just wipe clean
with a cloth. It has never, never, ever dried the chip out or caused it to fade.
If the chip has a hot stamp, I don't use the toothbrush on that part, I just dab
a little on with my finger and gently wipe it off with the cloth.
- I clean virtually all
of my chips except those that come straight from the cage and have never seen
play. I have also experienced no fading or drying out. The pink goop (Sterling
Magic) is great stuff.
I've been using Armor All Multi-Purpose Cleaning with
fantastic results for the past year, no damage to chip, luster and shine are still
there...and it cleans the chip. Don't use any other Armor All product i.e., tire
cleaner, window, bug, etc.
- Waterless
hand cleaner, non abrasive, with lanolin and a bath of Johnson baby oil will restore
the luster. Give it a bath of oil, let soak for an hour or so on a bath towel
turn once after a while wipe dry. Regular mineral oil is too oily
- I use a soft toothbrush
& Fantastik. I spray both sides of the chip & clean the dirt off with
the toothbrush & then rinse under warm water. I dry the chip with a paper
towel. I then use a VERY small amount of mineral oil (which brings out the true
colors of the chip which may have been lost over time or due to cleaning) rubbed
between two fingers & work it into the chip. That entire process should not
take more than a minute. I'll then let the chip dry for 24 hours on one side &
turn it over & let dry for another 24 hours before storing the chip.
- I used a soft children's
tooth brush and window cleaner. Hot stamps will turn from gold to silver, so they
get covered with my thumb and I only clean the mold designs. Chipco, Paulson graphics
BJ and others of like design are much more durable.
- I
don't clean many of my chips, but when I do I use Amway's L.O.C. (Liquid Organic
Cleaner and a baby's tooth brush (much softer than a regular soft toothbrush.)
I put a few drops of L.O.C. on the chip and brush very lightly. I so this to remove
the surface dirt. If the chip is extremely dirty I generally leave it alone. It
sometimes looks better dirty.
- Try
Johnson & Johnson baby gel instead of oils to restore the luster. I've been
told this by a noted chip collector and restorer.
Crest and seals - Clean with a 3M scouring pad or wet/dry sandpaper. Then
bring back coloring with Johnson & Johnson Baby Gel. (Note: the 3M scouring
pad is non-abrasive, it is sold for cleaning dishes.)
Before & After Using Sterling Magic!
How NOT to Clean Chips
- Don't
clean the hot stamp with a toothbrush, only gently rub the cleaner in with your
fingers.
- Never
use anything abrasive to clean your chips.
- Don't
use steam to clean clay chips, the steam will heat the chip until it softens and
will warp.
- I
did ruin a batch of old clays once by putting them in the washing machine with
bleach and Tide, it messed them up pretty bad and was very loud to boot.
- I find tying them up
in an old T-shirt and running them through the washing machine cycle usually does
the trick. However, for that really tough grime that gets lodged down in the bottom
of the cane in the hat&cane or the crevices in a small key mold, there's really
nothing like a good stiff wire brush and some elbow grease. A little Vaseline
to bring out the colors when you're done, and Viola! (This is meant as a joke.)
- Do not
clean a hot stamped chip with a toothbrush, instead gently rub with your fingers
- I have
had very good luck with Sterling's Magic cleaner. However, when I cleaned some
old Mint roulettes (this is the series with the small crown mold and a round white
inlay) I ended up removing a thin clear plastic cap that covers the inlay.
- Once I was cleaning (I
think a Diamond Jim) inlay chip with what I usually use -- dove hand soap bar,
toothbrush pared down and warm water, and water got under and discolored the inlay.
I think it must have happened because the inlay was weak/lifting some/damaged.
- Once
I really screwed up. I had a lot of dried out, faded embossed style poker chips
(maybe the Golfer wearing knickers) I often rub chips like these with sewing machine
oil (or mineral oil, or Vitamin E liquid). I'd apply the oil and rub it off right
away with a paper towel.....But
this time I left all the chips in a pot on
mineral oil overnight, and in the morning a found them practically ruined. As
I remember, the main
problem was that rings and crescents were left on the
chips where one chip rested on another.
